The engraving is handled by a special needle, which is pressed against the marked object with a pressure of 2 Bar.
Compared to a standard micro-punch machine, engraving marking is quiet and does not produce any vibrations or resonances.
With these machines, marking of a wide range of signs, shapes, 2D codes, etc. is possible. The messages are stored in the device’s memory and carry information about the required marking parameters.
Permanent marking is possible on almost all types of materials (metal, plastic, etc.).
The highly resistant marking is visible even after subsequent surface treatment, for example by color spraying, galvanizing or sandblasting.
Using this system, it is possible to mark extremely hard, irregular, flat and partially curved products.
Thanks to its extremely small dimensions, this system finds application especially where it is necessary to deal with extreme demands on spatial development.
Features:
- Dimensions of the description field: 75×15 mm
- material hardness: 62 HRC
- Needle drive: Pneumatic pressure 2Bar
- Engraving depth: up to 0.05mm
- Marking speed: up to 10 characters per second
- Power supply: 110/230V, 50/60Hz, input power 135W
- LOG marking option: YES
- Possibility of Datamatrix and QR marking: YES
- Profinet, Ethernet/IP, Profibus option: YES
- Control: 7″ Keypad, or 10″ touch screen
- SW for LOG creation: YES – free
- Types of marking needles: R14
